Set IP from command line

netsh interface ip

Usage:
set address [name=]
[[source=]dhcp | [source=] static [addr=]IP address [mask=]IP subnet mask]
[[gateway=]|none [gwmetric=]integer]

Parameters:
* name – The name of the interface.
* source – One of the following values:
o dhcp: Sets DHCP as the source for configuring IP addresses for the specific interface.
o static: Sets the source for configuring IP addresses to local static configuration.
* gateway – One of the following values:
o : A specific default gateway for the static IP address you are setting.
o none: No default gateways are set.
* gwmetric – The metric for the default gateway. This field should not be set if gateway is set to ‘none’.

The following options are used only if source is ‘static’:
* addr – An IP address for the specified interface.
* mask – The subnet mask for the specified IP address.

Remarks:
Used to change the IP address configuration mode from either DHCP to static mode or static mode to DHCP. Adds IP addresses on an interface with static IP address or adds default gateways.

Examples:

* set address name=”Local Area Connection” source=dhcp
* set address local static 10.0.0.9 255.0.0.0 10.0.0.1 1

netsh interface ip set address name=”Local Area Connection” static 192.168.0.250 255.255.255.0 192.168.0.1 1

Written by Komkid on April 16th, 2009 with 2 comments.
Read more articles on Admin and IT Tips and Networking.

Manage Stored User Names and Passwords

Windows สามารถช่วยจำ User name กับ Password ที่เราใช้งานผ่านเครือข่ายต่าง ๆ ได้
โดยให้เราคลิกที่ Remember my password

ซึ่งบางทีเราก็ลืมไปแล้วว่าได้บันทึกอะไรไว้บ้าง
Windows ได้เตรียมหน้าต่่างสำหรับจัดการ Stored User Names and Passwords นี้ไว้แล้ว
โดยพิมพ์ใน Command line ว่า

rundll32.exe keymgr.dll, KRShowKeyMgr

ก็จะได้หน้าต่าง ดังรูป

Written by Komkid on April 16th, 2009 with no comments.
Read more articles on IT Tips.